Hello CBR250R net members!
I bought a downed 2011 CBR 250 R in the interest of restoring the bike to it's former glory, but the cost of replacement parts was way higher then I ever imagined.
I have completely parted the bike down and begun to sell everything I can salvage off of the motorcycle. Bike went down on the right and broke almost every plastic piece. I have photos of almost everything for sale, but can only list so much on the site, give me a direct message for specific details.
I have some fast bike parts from it that include:
37MM Vortex 7 degree Clipons $100 **SOLD**
37MM Ricor Intiminators $160 (YOU CAN NOT BUY THESE NEW RIGHT NOW**SOLD**
I have already SOLD the following:
Rear Fender/License Plate holder
Left side Controls
Bent forks (one lower is useable)
For sale includes (plus anything not listed above likely!):
FULL ignition set with OEM key
FULL CLEAN TITLED FRAME (in my name)
1 Bar end
Both Seats (no tears, like new condition)
Rear tail light
BOTH WHEELS WITH ROTORS (no tires lol) - $200 SHIPPED and NO I won't sell you one wheel for $60.
Rear Cush drive, sprocket and hub as unit
Both Rearsets (one is bent)
Kickstand sensor switch
Tip over sensor
Clutch/throttle cables in great condition
Purge Control Solenoid Valve
Left Rear Grab bar
Right Handlebar controls (killswitch, starter)
Miscellaneous fairings with cracks and road rash
Full wiring harness (some rash to right turn signal)
Front brake caliper
Rear brake caliper
Message me with your buy price if you are interested in any of this. I'll keep shipping low as I have a lot of shipping materials here at the house.