Honda CBR 250 Forum banner

Discussions Showcase Albums Media Media Comments Tags Marketplace

1-7 of 7 Results
  1. Honda CBR250 General Discussion
    Hello my friend's I want to know your opinions my bike with 38k miles stopped working, the mechanic recommended that I replace the engine, crankshaft, valves, piston, coil, and other engine parts broke down. my question is the following, which is more profitable, buy an engine with low...
  2. CBR250 Service and Maintenance
    Should Spark plug torque be Honda's recommended 16Nm or NGK's recommended torque? My best guess is I assume Honda's because they know best what material the cylinder is made out of?
  3. CBR250 Service and Maintenance
    After doing a brake bleed I filled on an upright fluid level position the rear and front brake reservoirs. i filled to the upper mark on the rear one as specified in the owners manual and the front on until the inner casting mark as specified in the service manual. However when closing the caps...
  4. CBR250 Problems and Issues
    I’m driving and roving the check engine light flashes and and the it dies. And the Speedo Jumps like I could be driving 15 and clutch in and rev it and says im going 40 and jump around
  5. CBR250 Problems and Issues
    So I have this gap on one side of the axle someone please tell me if it’s normal I noticed in the group that someone has posted about this before but no real answers
  6. Honda CBR250 General Discussion
    My indicators all stopped working after a very wet road and lots of road water, they did temporarily start working now have died, everything else works and all fuses are fine. When pressing indicators I can hear a fast ticking have now ordered a relay for the bike. Anything else it could be?
  7. CBR250 New Member Introductions
    Yo im new to the forum. I used to have cbr 150 2012 repsol & currently using ninja 250 from 2015 till now. Months ago i bought used 2012 cbr 250 just for touring in my country. Im a big fan of modding bike especially 250 bike. Heres my progress in 1 month (not done yet) I used yoshimura r77 for...
1-7 of 7 Results
Top