Honda CBR 250 Forum banner
1 - 4 of 4 Posts

·
Registered
Joined
·
532 Posts
Discussion Starter · #1 ·
I've been reading various bike forums on the Internet, and noticed that for some bikes at least, there is a way to adjust the height of the shift lever/peg to allow for thicker boots.

I've went out and looked at the CBR, and I don't see (easily) how I'd do that on ours. Given I am a bit shorter (and can't flatfoot), I'm thinking of getting slightly bigger boots that aren't really 'sport' boots, and using my winter boots as a guide, think they might not fit properly under the lever/peg for shifting up.

Any ideas on how to do this on our CBR250Rs?

Thanks in advance
 

·
Registered
Joined
·
532 Posts
Discussion Starter · #3 ·

·
Registered
Joined
·
4,996 Posts
I wrote a guide somewhere for adjusting both if you can find them.
 
1 - 4 of 4 Posts
Top