Honda CBR 250 Forum banner
1 - 3 of 3 Posts

·
Registered
Joined
·
3 Posts
Discussion Starter · #1 ·
Hello fellow riders

Noob here.
The 2 clips (plastic loops) in the air filter compartment are broken (pic) . I'm holding the filter in place using a metal wire for a temporary fix.

Can you kindly help me with a better solution for this?
How do I get new set of loops there? Is it too much work? Will it cost me a bomb?


Motor vehicle Bumper Automotive tire Automotive exterior Gas
 

·
Registered
Joined
·
3 Posts
Discussion Starter · #4 ·
Hi Tamir

Thank you so much for providing the fix. You're the best!
I will go ahead and buy the element holder.

In your first picture I suppose you are trying to show the correct way of locking the filter in place, by pulling up the clip, correct?
The problem I faced was no matter how hard I pushed the filter up it refused to fall into the loop. Am I doing something wrong? Or is this normal?

And about the below tip, you are referring to the filter cover screws, Correct ?

TIP: When you tightening the screws to the plastic threads, a low torque should be used (not destroy the plastic threads).

Thanks for the video, I'm still trying to understand it though!
 
1 - 3 of 3 Posts
Top