Honda CBR 250 Forum banner

Drilling airbox experiment

1425 Views 9 Replies 5 Participants Last post by  DannoXYZ
I removed the rubber elbow that goes into the airbox and dremeled out about a 4 square inch hole on the bottom piece of plastic between the battery and airbox. Butt dyno says it made a non-negligable difference. As you know, power falls flat on its face after 8k rpm and this seemed to help extend the torque curve a bit. Anyone have other mods to help it breathe better up top?
  • Like
Reactions: 1
1 - 1 of 10 Posts
1 - 1 of 10 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.