[MMMII]

So, I got around to installing my Yoshimura TRC slip-on today. Looks good but sounds even better. All went well with the install except for the factory exhaust clamp was a PITA to loosen up..

My question is about the Honda factory muffler mounting bolt and the Yoshi muffler clamp orientation. Is the Yosh muffler clamp supposed to mount on the insider (closet to the tire) or the outside like my picture below? I second guessed my mount and tried to mount it to the inside and couldn't get it to line up. I only tried for a few minutes before I changed it back and decided to snap a pic and ask the smart folks here before I start dropping F-bombs in the garage.

Any help is appreciated, thanks!

 

[fieldeffect]

it goes on the outside like you have it in the picture.. i have a leo vince and wondered the same thing. wouldnt fit the other way so im guessing the way you have it is correct.

 

[MMMII]

Thanks. I don't see how much of a difference it would make if it was on the other side.

 

[250 Tom]

Its right good job looks great. I got the yosh slip on to but didnt get the carbon fiber tip. Wish I would have like the looks of it better

 

[dimensi]

that is the right place!