Honda CBR 250 Forum banner

Rear turn signals (BMW 3)

1503 Views 2 Replies 2 Participants Last post by  Rotorboy
I would like to post a picture of where these would mount but I cannot upload a pic at this time so please bear with me. I was thinking about using these 2006 BMW 325i Side Marker Replacement, Front, Passenger Side, Clear lens, Plastic lens, DOT, SAE compliant, OE replacement, With bulb(s) mounted just below and to the sides of the tail light when doing a DYI fender eliminator. Do you think they would work well and look good as turn signals?
1 - 3 of 3 Posts
you would have to buy the male ends of the electrical connectors in order to get a watertight seal and then figure out an attachment setup. i like the shape and size of them but think it would be too much trouble myself.
thanks for the reminder about needing to be water tight. I will investigate further.
1 - 3 of 3 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.