Honda CBR 250 Forum banner
1 - 2 of 2 Posts

· Registered
Joined
·
3,527 Posts
close enough

Did my valve inspection last, and no surprise my exhaust valves are still tight. They measured at .009, and the intakes at .008.
My intake valve clearance were dead on at .006 inches and my exhausts were close to correct at .010 and .009. Spec is .011 inches so I decided to leave them as is for a few more thousand miles
 

· Registered
Joined
·
3,527 Posts
900

Sendler, how many miles on your bike. Your exhaust at .010 is within spec, but the .009 is tight. Only risk is tuliping the valves if we continue to run them too tight.
I had 900 on it when I checked it. 2000 on it now. I won't bother changing the shims for .002. What are the increments of adjustment that are available for the shims?
 
1 - 2 of 2 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top