Honda CBR 250 Forum banner
1 - 15 of 15 Posts

·
Registered
Joined
·
576 Posts
Discussion Starter · #1 ·
took off the pipe shields to paint high gloss black to
match the rest of the black trim.

i like the look/sound of the stock pipe,i fool around with gopeds
so i have some extra pipe wrap laying around.
might just do the end like a stinger look.
just leaving the shields off.
 

·
Registered
Joined
·
576 Posts
Discussion Starter · #12 · (Edited)
ha ha.

probably going with an aftermarket after some
more have been developed/put out.
i just cant stand the shields,to bulky looking.
i was going to use some big clamps but stainless steel wire
looks better i think.
they do paint up nice.many coats.wet sanded
inbetween coats:D
 

·
Registered
Joined
·
576 Posts
Discussion Starter · #15 · (Edited)
i've had alot of bikes through the years
much more agressive than this,got it for the
good gas mileage.been tooling around lately
on some reeded gsr tsi 40's but the police are cracking
down on registations and left me with only the truck
which i hate to spend the gas for just around
the house and store.

i'm deffinetly getting a slip on later.
but for now i'm leaving the wrap.
thought it would at least get one
positive vote:(oh well at least it
will be unique:)

a couple of these will smoke this cbr up to 45-50mph.
 
1 - 15 of 15 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top