[Norton]

My CBR has almost 45,000km on the clock. The front brake disc has been worn. I already have a new brake disc. It is used, but I was able to buy it in very good condition. Taking advantage of the winter, which makes it impossible to ride a motorcycle, I want to replace the disc and at the same time I will put on new brake pads. Unfortunately, I don't have a service manual.

Could any of you who have a service manual write how many Nm I should tighten the front brake disc to the wheel?

Thank you in advance for your help.

 

[Tamir]

20Nm, in a crisscross pattern, in 2 or 3 steps [P. 13-19]

 

[Norton]

Tamir, should I treat these brake disc bolts with Loctite?

 

[Tamir]

Tamir, should I treat these brake disc bolts with Loctite?

Yes, a red Loctite.
The Honda's recommendation is to buy a new screws [P.13-19],
and the new screws have Loctite on them, in this case a red Loctite.
Since these are special screws, you must not buy a normal screws, but only the original ones.
Catalog number: 90106-KGH-600 (LINK)

 

[cts]

[QUOTE = "Norton, post: 692220, membro: 81087"]
Sfortunatamente, non ho un manuale di servizio
[/ PREVENTIVO]
È qui: ITALIA Honda CBR 250R - Manuale d'officina = 0
Ciao.

 

[Norton]

Cts thank you very much for your help

Thanks to the service manual, I realized that I also have to replace the screws from the ABS ring with new ones

I will soon order the necessary elements and start replacing the brake disc. I will write how I did in this thread.

All the best

 

[Terry66]

Following thread